New
Creative idea
Start DIY Kit: Lær at lave kumihimo-armbånd og mininøglering
#v16715
Here you can learn how to make your own bracelets and mini key rings on a kumihimo knotting disc. Videos will teach you how to make patterns with stripes and dots, which eventually become the cutest friendship bracelets or key rings.
#v16715
How to do it
How to do Kumihimo Get step by step instructions on how to do Kumihimo.
Dotted pattern Cut two colours of cord: 3 red cords of 1.3 m and 1 pink cord of 1.3 m.
How to braid a dot pattern on a kumihimo knotting disc Click to see the instructions (video).
Striped pattern Cut four different-coloured lengths of cord, each 130 cm long.
How to braid a striped pattern on a Kumihimo knotting disc Click to see the instructions (video).
Candy-striped pattern Cut two colours of cord: 2 x 130 cm and 2 x 130 cm.
How to braid a candy-striped pattern on a Kumihimo knotting disk Click to see the instructions (video).
7 Braid just under half of the bracelet’s finished length and remove one of the cords from the braiding disc. Then thread the cord onto a big eye beading needle and thread on beads.
8 Remove the cords from the braiding disc and knot a double knot with two cords of the same colour around the rest of the cords.
9 Push one of the beads up to the knot and make another double macramé knot.
10 Knot a double knot between each bead and finish with another double knot.
11 Put the work back into the braiding disc and place the cords in pairs in the same way as you did at the start.
12 Make a key chain using the kumihimo technique – first, pull the cords through the key ring and place the ring in the middle of the cord. With the key ring in the middle, attach the eight ends to the braiding disc and braid as shown in steps 2, 4 or 6.
13 Use the ends of the braided bracelet to tie the bracelet around your arm – or attach it with a jewellery clasp.
14 Measure around your arm to determine how long the bracelet should be. Take a little bit off for the jewellery clasp and O-ring – about 1.5 cm. Now cut to length.
15 Squeeze or glue end caps around the braided bracelet depending on the type of end cap you use.
16 Open an O-ring by twisting the two ends in opposite directions with two pairs of jewellery pliers. Insert both end caps and jewellery clasp into the O-ring and close the ring by twisting the ends back in place. Repeat this process at the opposite end of the bracelet, but here only the O-ring and end caps are joined.
Also go exploring in
