Stamped designs using foam rubber sheets
How to do it
Cut an 8.5 x 18.5 cm piece of foam rubber or to your chosen size. Etch the design into the foam rubber sheet using a pencil, creating an indentation where you draw with the pencil. A tip: Draw thick lines as these a more visible on the finished print.
Roll paint onto the etched design on the foam rubber sheet.
Transfer the design onto a piece of watercolour paper. Press firmly (not too hard) onto the back of the foam rubber sheet as there can be some paint left in the indentations.
Cut out the printed design and attach it onto the inside of a tray using matt decoupage lacquer. Attach a picture hanger onto the back of the tray and use as a picture frame.
A tray with a glued-on patterned design.
Copyright © 2013-present Magento, Inc. All rights reserved.