Creative idea
A Pirate Keyring Fob from Shrink Plastic
#v14856
These pre-printed designs on shrink plastic are coloured in with colouring pencils. The figures are cut out, a hole is made at the top, they are shrunk in a household oven at 170°C and attached to a keyring to make a key fob.
#v14856
How to do it
1 
Colour in the pre-printed design on the shrink plastic sheet.
Colour in the pre-printed design on the shrink plastic sheet.2 
Cut out the figure with a pair of scissors and make a hole at the top using punch pliers. It can then be attached as a key fob on a keyring. Remember that the hole shrinks as well.
Cut out the figure with a pair of scissors and make a hole at the top using punch pliers. It can then be attached as a key fob on a keyring. Remember that the hole shrinks as well.3 
Place the figure on a baking sheet covered with baking paper. Put in a household oven at 170 °C. After a few minutes the figure will start to shrink and curl up and then it straightens out again and can be taken out of the oven.
Place the figure on a baking sheet covered with baking paper. Put in a household oven at 170 °C. After a few minutes the figure will start to shrink and curl up and then it straightens out again and can be taken out of the oven.4 
Attach the figure to the keyring using a round jump ring. Now squeeze the round jump ring with flat nose pliers to close it.
Attach the figure to the keyring using a round jump ring. Now squeeze the round jump ring with flat nose pliers to close it.Also go exploring in
