Jewellery wire earrings and ring
#v16965
Make delicate jewellery out of sturdy jewellery wire – three sets of earrings and a ring. Follow the template and bend the jewellery wire into beautiful, organic shapes. Decorate the jewellery with small pearlescent white wax beads.
#v16965
How to do it
1 Cut a piece of jewellery wire that is 24 cm long.
2 Shape the jewellery wire according to the template, as shown in the picture.
3 Add beads and a stud earrings to the jewellery wire.
4 Finish the earring by gluing a bead onto the end. Once the glue is dry, your earring is ready to use. Repeat for process for the other earring. If you want to create a different look, you can use the other template provided.
5 Cut a piece of jewellery wire that is 14 cm long.
6 Make two loops as shown in the picture. The bow template included shows the size of the bow.
7 Bend the top long piece around the middle of the loops as shown in the picture.
8 Bend the top long piece down over the middle of the loops. It is important that you have a small loop in the middle of the bow because this is where the stud earring will be attached.
9 Cut off the excess wire.
10 Glue beads onto the ends of the bow as shown. Let the glue dry.
11 Twist open the small round jump ring on the stud earring using flat-nose pliers.
12 Attach the ring on the stud to the loop in the middle of the bow and close the stud’s round jump ring using flat-nose pliers. The earring is now ready to be worn. Repeat for process for the other earring.
13 Cut a piece of jewellery wire that is 13 cm long.
14 Bend the wire as shown in the picture, adjust it to fit your finger and then cut off the excess jewellery wire.
15 Glue beads onto the ends of the jewellery wire and allow the glue to dry. Once the glue is dry, your ring is ready to use.
Also go exploring in
