A Hanger made from Faux Leather Paper Weaving Strips and Rivets

1 The finished hanger measures approx. 85 cm in length. Cut two 175 cm and one 26 cm faux leather paper weaving strips. Put the short paper strip around the top of the glass tea light candle holder and make a mark for a rivet.

2 Make a hole for a rivet.

3 Set the rivet by striking the rivet setting tool with a hammer.

4 Place the finished faux paper ring around the glass candle holder.

5 Form a cross with the two 175 cm faux paper strips and make a hole with revolving hole punch pliers.

6 Set a rivet.

7 Place the glass holder in the middle of the cross. Pull one of the faux paper strips up to the faux paper ring and make a mark for a rivet.

8 Double over both faux paper strips to make a hole in all four strips at the same time.

9 Place the glass holder onto the cross, slide the faux paper ring down to the bottom of the glass holder and mark for rivets on the faux paper ring.

10 Make holes for the rivets.

11 Assemble the hanger with the rivets.

12 Measure 6 cm and 4 cm from the end of each of the four faux paper weaving strips and make holes for rivets.

13 Set the bottom rivet first, attach a wooden ring and set the top rivet.

14 Trim the excess faux leather paper weaving strips.